Optical Theremin Built From Snap Circuits
Using Radio Shack's Snap Circuits kit and a common 555 timer IC, Instructables.com member KRA5H designed this simple optical...
Recent Forum Posts
-
by dewster on Let's Design and Build a (mostly) Digital Theremin! 7 hours ago -
by oldtemecula on One-handed theremin with two antennas on the same side 2 days ago -
by nclm on Playing the theremin with headphones, a few questions 2 days ago -
by dewster on Theramin or Theramini? 3 days ago
-
by dewster on Build Project: Dewster's D-Lev Digital Theremin 3 days ago
Recent Comments
-
by merula on article A very special Theremin Academy will happen in Lausanne/Switzerland in February 2019 37 days ago:
"Where can I get one of those boxes?"
-
by Dominique on photo The DC heater supply 52 days ago:
"I used veroboard for the print. Veroboard is OK with voltages up to 50V."
-
by Dominique on photo The inside 52 days ago:
"All shielded cables are 2 wires shielded cables. With these, it is possible to use one wire for the signal ground, one wire for the signal, they will..."
-
by Dominique on photo The inside 52 days ago:
"The coils with the white strong paper are hand made coils. I keep these sheets of paper as it, because as long I am working on that project, they are..."
-
by Dominique on photo The antennas version 2 52 days ago:
"The shields provides a good protection against noises like hum."